Eagler's Nest
Airframes => Single Seaters => XL => Topic started by: grdev on February 18, 2014, 07:44:32 AM
-
I was going to weld on m wing mounts today, but I couldn't locate any .062" 1/2" square 4130 tubing in my stock I recently purchased using the XL material list provided with my drawings. looking over my materials list I see it isn't listed. The only 1/2" sq stock I see listed is a one foot piece of .035 & .049.
I started looking at every page of my drawings looking for where square stock was used and this is all I could find:
Pages
7A wing mount .062" x 1/2"
10 control stick ..035? x5/8"
21 rudder stop .065 x 1//2
Where s the 1' of 7/8" .065, 1' of 1/2" .035, & 1' of 1/2" .049" used?
I've been known to miss the obvious before, any help appreciated.
-
I found where the 7/8" was used, I'll:-[ keep searching
-
I am in the same boat I didn't buy any 1/2 by .062 square tube either because it wasn't on the list but it is called out on the drawing for the wing mount. Guess I'll be ordering more material. I need some . 090 flat material anyway.