I'm not there yet, but looking ahead at how to finish off the end of the wings while I make my last few ribs. I don't see anything in the plans drawings yet Leonard's narrative says at one point " Now's a good time to cover the end ribs with .8mm ply " . If you are covering the ends with plywood, would it be prudent to omit the gussets on the outer sides of the end ribs and go with one full sheet of ply instead ? If you put ply on over the gussets the ply would not have much to hold onto so would you be tempted to fit in some .8 mm strips as fillers in between the gussets ? Dannen Compton's excellent site shows gussets on the outer part of the end wing ribs. Are you covering the wing end with fabric instead of ply ? If so, would you then put some of those .8mm strips in between the gussets to leave the fabric something better to rest upon ? Any and all ideas welcome. Thanks.