Engine mount? Help needed rubber mount location ect. Thx Gary

[cheto]

Thanks, Keith. That's helpful but doesn't really answer my question. Sorry for not being clearer. On page 8A of the LEXL plans, the aluminum filler and steel tube both have a 45-degree inside taper to match the rubber mounts. How did you cut that 45-degree taper? Is there some kind of special bit that I could chuck in my small bench-top drill press? Or maybe it could be cut free-hand with a Dremel? I don't think I can get a hand-file in that space. -Chet   

[Kamcoman77]

I used black Delrin instead of aluminum for the inner slide. I cut the bevel with a large drill bit. The 4130 tubes were cut on a lathe.

[cheto]

Thanks