Washers for shock struts

[Shay King]

Just wondering what washers builders are using for the shock struts (spring retainers) on the XL landing gear. Is there a suitable item available online or is it simpler to just cut them out of 1/8” plate?

[Kiwi55]

I cut them out of 1/8 plate. I used a holesaw and the drilled the center hole to fit.
...Paul

[Shay King]

Thanks Paul,
I don’t have the springs yet, what outside diameter did you make them?
Regards,
Shay.

[Kiwi55]

Thanks Paul,
I don’t have the springs yet, what outside diameter did you make them?
Regards,
Shay.

For the springs I got my OD was 1 3/4" (But I'm building the heavier Cabin Eagle)

[Shay King]

I went ahead and cut them out of 1/8” plate. They’re not perfectly round but I think they’ll do. I’m wondering if anyone welds both sides of the washers?

[Chuck in Indiana]

^^^^ No need.